Note: You are viewing this page without the associated stylesheet. You may want to update your browser for optimal viewing performance. If you continue you may want to skip to the page contents.

Our approach to weatherseal solutions considers the entire system. From concept to commercial success, our value extends well beyond the materials we sell. It addresses your needs from manufacture, assembly, and long-term performance with weight savings, part consolidation, and experienced design assistance. This is shown in the number of injection molded seals on a car. There are special grades of Santoprene TPV designed for bonding 2 TPV or EPDM rubber seals together in a corner or adding attachment points or end caps to extrusions. There are also high flow grades designed for 2 shot molding seals onto plastic components like cowl vent grills.

Injection molded corner

Injection molded end caps

Injection molded cowl vent grill seal

Injection molded corner molding

Molded end cap

Injection molded water drain seal